• Album: Starting Battery Shelf
  • Ooops!! Catalina must have run out of wire or measured wrong on this run...
    Tuesday, October 30 2001 @ 04:06 AM EST
    0 Comments
    Views 2234
  • VBerth Wiring Channel with panel removed. Catalina used screws that were a little too long and caused star cracks and puckers on the deck. I had to use Captain Tolley's Creeping Crack Cure to fill them.
    Tuesday, October 30 2001 @ 04:06 AM EST
    0 Comments
    Views 2314
  • New Terminal Board where the Shunt, Fuse and Parallel charging solonoid were mounted. This is before all the low power wiring was attached. The 250 Amp House bank protection Fuse is on the far right. The 400Amp current measuring Shunt is in the center, an
    Monday, April 22 2002 @ 09:19 PM EDT
    3 Comments
    Views 2672
  • Routing New Alternator Power and Control wires over to the batteries. The blue flex conduit I got at Home Depot, and pulled the 4AWG wire through it before feeding it to the batteries.
    Sunday, November 16 2008 @ 06:36 PM EST
    0 Comments
    Views 2306
  • New Alternator Power and Control wires
    Saturday, May 11 2002 @ 02:36 PM EDT
    0 Comments
    Views 2480
  • A shot of our new High-output AmpTech 125se alternator. I ran 2 new 4-gauge output cables directly to the battery bank and a pair of 12-gauge wires for the to the new NextStep regulator
    Sunday, November 16 2008 @ 06:36 PM EST
    0 Comments
    Views 2610
  • This is the Ample Power NextStep Regulator I added to control the High Output AmpTech (125amp) alternator I installed. A picture of the installed alternator is here.
    Sunday, November 16 2008 @ 06:36 PM EST
    0 Comments
    Views 2393
  • Note the extra circuit breaker on the bottom near the Tach. This was added for the 12v outlet.
    Tuesday, January 01 2002 @ 07:35 PM EST
    0 Comments
    Views 2649
  • Original 1-2-both switch before electrical system upgrade. BTW, This entire panel, Switch, board and all is available if anyone needs one. I replaced the whole thing with a new board and different switches.
    Friday, November 16 2001 @ 03:14 PM EST
    0 Comments
    Views 2242
  • Ample Power EMONII and new house/starting battery panel from Blue Sea. Also changed the Anchor Windlass breaker since I didn't care much for the old one and the old panel had to go anyway. Perhaps this year I'll hook up the laptop computer serial interf
    Sunday, November 16 2008 @ 06:37 PM EST
    0 Comments
    Views 2566
  • Standard Horizon Intrepid RAM Mic and the 12v outlet installed in the engine pod.
    Tuesday, January 01 2002 @ 07:35 PM EST
    0 Comments
    Views 2890
Jump to
  • 1
  • 2
Album ID: 147 
Sort By


Photo Gallery
New ForeSpar 3/4" ThruHull for the holding tank vent
Who's Online
Guest Users: 62
What's New
No New Items