• It's hard to take pictures in this little space, but these give you an idea how it was done. I can easily fit a group 27 starting battery in there. These pictures don't show blocks and straps that screw in and hold the battery from sliding around.
    Saturday, January 01 2000 @ 03:00 AM EST
    0 Comments
    Views 3125
  • The shelf board itself is marine plywood, that has been "painted" with epoxy so that it cannot absorb water.
    Saturday, January 01 2000 @ 03:00 AM EST
    0 Comments
    Views 2996
  • I used blocks epoxied to the hull and the settee base around the inside at the level I wanted the shelf.
    Saturday, January 01 2000 @ 03:00 AM EST
    0 Comments
    Views 3363
  • The shelf rests on the Blocks, and is epoxied in place using fiberglass mat to ensure it stays put.
    Saturday, January 01 2000 @ 03:00 AM EST
    0 Comments
    Views 2948
  • I added a Starting Battery Shelf forward of the 4D bank. This required adding a shelf since that compartment is deep and narrows at the bottom.
    Saturday, January 01 2000 @ 03:00 AM EST
    0 Comments
    Views 2662
Jump to
Album ID: 148 
Sort By