• Close up of 300A ANL fuse and holder (cover removed)
    Tuesday, March 24 2009 @ 05:54 PM EDT
    0 Comments
    Views 1174
  • 300A ANL fuse in line to engine (starter/alternator)
    Tuesday, March 24 2009 @ 06:03 PM EDT
    0 Comments
    Views 1414
  • Balmar ARS-5 external voltage regulator mounted in engine compartment.
    Sunday, July 20 2008 @ 03:20 PM EDT
    0 Comments
    Views 3172
  • Top view of Balmar alternator. Note 130A ANL fuse on alternator output in lower right and external voltage regulator mounted inside engine compartment on upper right.
    Sunday, May 25 2008 @ 04:22 PM EDT
    0 Comments
    Views 1746
  • Balmar 120A high output alternator installed on Yanmar 3GM30F.
    Sunday, May 25 2008 @ 04:21 PM EDT
    0 Comments
    Views 4216
  • Magnum ME-RC remote panel that controls and monitors the charger / inverter.
    Saturday, July 05 2008 @ 08:50 PM EDT
    0 Comments
    Views 1325
  • General location of Magnum RE-RC panel in relation to the power distribution panel on port side.
    Saturday, July 05 2008 @ 08:50 PM EDT
    0 Comments
    Views 1352
  • AC wiring from inverter output to "outlet" circuit breaker (black wire).
    Thursday, July 31 2008 @ 05:08 PM EDT
    0 Comments
    Views 1482
  • Added small terminal block to tie in inverter AC output to AC outlet common connections (white wires) which are isolated from other white common wires. Black wire goes to "outlet" circuit breaker only.
    Saturday, July 19 2008 @ 03:31 PM EDT
    0 Comments
    Views 1652
  • 100A circuit breaker from battery connection to inverter/charger. The unused red cable is from forward battery (now part of battery 1) that is disconnected at battery end by removing fuse from inline fuseholder at battery. I plan to move this to the aft
    Saturday, July 19 2008 @ 06:20 PM EDT
    0 Comments
    Views 1442
  • Xantrex Link 20 battery monitor (previously installed).
    Monday, July 25 2005 @ 09:36 PM EDT
    0 Comments
    Views 1983
  • Magnum MMS 1012 battery charger / inverter installed in orginal battery charger location. AC input is original AC wiring from "charger" circuit breaker. Added #14 AWG wires carry inverter AC power back to distribution panel.
    Saturday, July 19 2008 @ 06:19 PM EDT
    0 Comments
    Views 2152
Jump to
  • 1
  • 2
Album ID: 8 
Sort By