Slide Show  
New Terminal Board where the Shunt, Fuse and Parallel charging solonoid were mounted. This is before all the low power wiring was attached. The 250 Amp House bank protection Fuse is on the far right. The 400Amp current measuring Shunt is in the center, an
Image 3 of 15
Comments 3
Views 3951
Media ID 20081116153647796 
Monday, April 22 2002 @ 09:19 PM EDT
Uploaded By: Jeffrey Hare  

 

Share It!

Jump to: 

Media Properties

Media ID 20081116153647796  
Date Monday, April 22 2002 @ 09:19 PM EDT
Comments 3
Views 3951
Uploaded By Jeffrey Hare
  • New Terminal Board where the Shunt, Fuse and Parallel charging solonoid were mounted. This is before all the low power wiring was attached. The 250 Amp House bank protection Fuse is on the far right. The 400Amp current measuring Shunt is in the center, an
  • 3 comments
Login required to comment
can you tell me where the secand red cable by the alltech charger is going to one is going to the battery and the other one? h.boeren nederland
What? No protective covers/caps on the pos. terminal posts.
This was a temporary setup board. The solenoid is now a Blue Sea ACR, and the terminal on the far left is covered. The rest of what you see here is all on the Ground bus and doesn't need to be covered, but could have a plexi shield mounted over it.